全新美國*Microsemi  flashpro5 usb下載線 現貨

全新美國*Microsemi flashpro5 usb下載線 現貨

全新美國*Microsemi flashpro5 usb下載線 現貨

FlashPro5 Device Programmer Quickstart Car

This quickstart card applies only to the FlashPro5 device programmer.

Kit Contents

Software Installation

FlashPro or FlashPro Express software is automatically installed as part of the Libero^® System-on-Chip (SoC) software. If you are using the FlashPro5 device programmer for standalone programming or on a dedicated machine,

download and install the latest release of the FlashPro or FlashPro Express from the Microsemi^® website. The installation will guide you through the setup. Complete the software installation before connecting the FlashPro5

device programmer to your PC.

Note: The minimum version requirements to run FlashPro5 on Windows are Libero SoC v11.3/ FlashPro v11.3 and on Linux are Libero SoC v 11.4/ FlashPro v11.4:

www.microsemi。。ｃｏｍ/products/fpga-soc/design-resources/programming/flashpro

Hardware Installation

After installing the software successfully, connect one end of the USB cable to the FlashPro5 device programmer and the other end to your PC’s USB port. The Found Hardware Wizard will open twice. Use the wizard to install the driver automatically (recommended). If the Found Hardware Wizard cannot find the drivers automatically, then ensure you have properly installed the FlashPro software prior to installing the hardware. If the drivers still cannot be installed automatically, then install them from a list or specific location (advanced).

If FlashPro was installed as part of the Libero SoC default installation, the drivers are located at C:/Libero/Designer/Drivers/Manual. For a standalone Libero SoC FlashPro default installation, the drivers are located at C:/Microsemi/FlashPro_<ver>/Drivers/. Microsemi recommends the automatic driver installation.

Pin 4 on FlashPro5 programmers MUST NOT be connected or used for anything other than its intended purpose.

Common Issues

If the On LED does not light up after FlashPro5 driver installation, the driver might not be installed correctly and you must troubleshoot the installation. For more information, refer to the FlashPro Software and Hardware Installation Guide and the “Known Issues and Workarounds” section of the FlashPro software release notes: www.microsemi。。ｃｏｍ/products/fpga-soc/design-resources/programming/flashpro.

FlashPro5 may not operate correctly if pin 4 of the JTAG connector is improperly used.

Documentation Resources

Refer to the FlashPro software page for further information:

www.microsemi。。ｃｏｍ/products/fpga-soc/design-resources/programming/flashpro

Technical Support and Contacts

Technical support is available online and by .To find your local representative visit Microsemi SoC Sales offices, including Representatives and Distributors which are located worldwide.

CE (European Conformance)

This product complies with the requirements specified in EMC Directive 2004/108/IEC and RoHS Directive 2011/65/EU.

***************************************************

聯 系 人 ;雷 俊 （先 生）

深圳博瑞圖電子科技有限公司

0755-36675904

MOB:13823138950

0755-83244576

ADD:深圳市福田區中航路世紀匯都會軒1416室

: 401512450

網     址：www.szprotools。。ｃｏｍ

***************************************************

承接銷售元器件IC一條龍、專注10年