瑞典Friborg介電強度架

介電強度保持器用于測試電介質的強度。
絕緣材料薄片。樣品材料放置。
在兩個電極之間和一個高電壓被施加到
電極。
注：測試需要一臺高壓發電機，見6500—

瑞典Friborg介電強度架

系列
技術規范
模型6580
•根據IEC 60065標準條款10.4.2圖6
（第10.3.2前版標準）
•兩根5毫米的電極，圓柱與平面端部
•可動頂電極的重量：100克
•絕緣框架來避免風險的危害。頂重絕緣
從電極
•4毫米香蕉插頭連接器（安全型）連接
高電壓
•用于薄片絕緣材料，但可以處理
大約12毫米厚的樣品
模型6585
•根據IEC 60598第10.2條
•兩個20毫米球形電極
•可動頂電極的重量：2 N
•絕緣框架來避免風險的危害。頂重絕緣
從電極
•4毫米香蕉插頭連接器（安全型）連接
高電壓
•用于薄片絕緣材料，但可以處理
大約10毫米厚的樣品

The Dielectric Strength Holder is used to test the dielectric strength of
thin sheets of insulating materials. The sample material is placed
between two electrodes and a high voltage is applied to the
electrodes.
Note: A high voltage generator is needed for the test, see 6500-
series
Technical Specification
Model 6580
• According to IEC 60065 Clause 10.4.2 Fig 6
(Clause 10.3.2 in previous edition of standard)
• Two 5 mm electrodes, cylindrical with flat ends
• Weight of moveable top electrode: 100 g
• Insulated frame to avoid risk of hazard. Top weight insulated
from electrode
• 4 mm banana-plug connectors (safety type) for connection of
high voltage
• Intended for thin sheets of insulating material, but can handle up
to approximay 12 mm thick samples
Model 6585
• According to IEC 60598 Clause 10.2
• Two 20 mm ball shaped electrodes
• Weight of moveable top electrode: 2 N
• Insulated frame to avoid risk of hazard. Top weight insulated
from electrode
• 4 mm banana-plug connectors (safety type) for connection of
high voltage
• Intended for thin sheets of insulating material, but can handle up
to approximay 10 mm thick samples