工作原理：

       光電傳感器方便地卡裝在一根ф25毫米的軸上。調試時，首先固定好定向板的位置，然后接通光電傳感器的電源，松開卡箍，對準定向反光板，調整光電傳感器的位置，直至8個發光管全部點亮為止。鎖緊卡箍，用一塊非透明材料遮擋光電傳感器，如果發光管全部熄滅，說明光電傳感器工作正常，當傳感器和系統連成閉環而處于自動糾偏狀態時，光電傳感器后面的發光管應有一半左右點亮。

     
      光電傳感器出廠時已經調整好，用戶切勿隨意拆卸，特別是光路部分，出廠時已用樹脂密封以防止水氣塵埃等侵入，一旦拆卸必遭破壞。

   Working principle:

Photoelectric sensor card conveniently in a ф 25 mm shaft. When debugging, first of all, the location of the fixed orientation plate, and then through the power of the photoelectric sensor, loosen the clamp, directional reflector, adjust the position of the photoelectric sensor until all eight light-emitting tube light. Lock clamp, cover with a piece of opaque materials photoelectric sensor, if the light tube out entirely, photoelectric sensor working properly, when the sensor and the system into the closed loop and is in a state of automatic adjustment, photoelectric sensor at the back of the luminous tube should be about half of the light.

Photoelectric sensor have been adjusted when delivery from factory, the user do not free disassembly, especially the light path, the factory has been sealed with resin to prevent moisture such as dust, will be destroyed once removed.

GPS3-1反射式光電傳感器 ——感謝有您，讓我結識了一位外國顧客