正確地使用和維護保養是機器正常運行，延長使用壽命，保持高性能和高指標的關鍵。在日常分析中要按以下要求和方法對ICP光譜儀進行維護和保養。
Proper use and maintenance is the key to the normal operation of the machine, to extend the service life, to maintain high performance and high indicators. Maintain and maintain the ICP spectrometer as per the following requirements and methods in daily analysis.
您在使用ICP-OES光譜儀和保養時還應注意以下幾點：
You should also pay attention to the following points when using ICP-OES spectrometer and maintenance:
1、退出OIA軟件并關閉激發臺光源開關(紅色按鈕)
1, exit the OIA software and turn off the ignition light switch (red button)
2、取下燃燒室兩側的螺絲，向上移開燃燒室。
2, remove the screws on both sides of the combustion chamber, the combustion chamber.
3、用專用毛刷(或者脫脂棉)清掃鎢電極周圍和燃燒室里面的黑色廢渣(嚴禁使用酒精等液體)。
3, with a special brush (or absorbent cotton) to clean the tungsten electrode and the combustion chamber inside the black waste residue (prohibit the use of alcohol and other liquids).
4、清理完畢裝上燃燒室，打開光譜儀軟件和激發光源(紅)后，氬氣吹掃十幾分鐘。
4, clean up the combustion chamber installed, open the spectrometer software and excitation light source (red), argon blowing more than ten minutes.
注意：不要將大塊物體落入排氣孔內，以免堵塞排氣管道。
Note: do not put large objects into the exhaust hole, so as not to block the exhaust pipe.
只要做到以上幾點，然后熟悉熟練的應用，你就會發現原來ICP光譜儀輕松維護是如此的簡單。
As long as the above points, and then familiar with skilled application, you will find that the original ICP spectrometer easy maintenance is so simple.
