1,可燃?xì)怏w和腐蝕性氣體中的水分分析檢測
2,響應時間短和高靈敏度
3,多功能液晶顯示器和微處理器控制
4,自動調節和遠程控制
5,RS232端口和報警輸出
TMA 204
Principle of Operation The P2O5-sensor uses the principle of dissociation of water to hydrogen and oxygen. The sensor element itself consists of a round glass body on which two electrodes are wound at constant distance. Depending on the sensor type these electrodes are either made out of platinum- or rhodium wire. Between these electrodes a thin film of phosphoric acid (H3PO4) is applied. The sensor-current causes the water contained in the acid to dissociate to hydrogen and oxygen. The result of this process is P205 (diphosphorous pentoxyde). P205 is a highly hygroscopic substance which absorbs the water from the sample gas. Through continuous dissociation of the water a balance between the water content of the sample gas and the water which is being dissociated builds up. The electrolysis current is proportional to the water content in the sample gas. It is displayed on the instrument readout after it is processed by the instruments signal amplifier. This principle of measurement can be used on all gases (Cl2, HCl, H2S, H2SO4, HBr, SO2, SF6, CO2, PH3, all inert gases and hydrocarbons) except those which chemically react with phosphoric acid or polimerise. Analyzer
| The Analyzer The new trace moisture-analyzer TMA is fully microprocessor-controlled and is designed to operate in rough field service. The amplifier is a high technology, solid state unit which is available as a desk-, as a portable version and as a 19"-rack. 2 alarm-levels can be set, 5 potentialfree contacts for range identification, one analog output and one serial port RS 232 are integrated. For remote control there are 5 isolated input contacts to switch the ranges externally. The system can be set in 4 modes: manual, RS 232, external, auto-range. The high quality LC-display shows the measuring result in ppm/v, the alarm-levels which are set and also the mode (for example: auto ranging). The cable-clamps of the sensor are of special high quality water proof connectors. After switching on the unit, the instrument automatically does a self-check (zero-/span-control) To measure in explosive hazardous areas the unit will be fitted with safety barrieres (intrinsically-safe, zone 1). A portable unit with rechargeable battery and built in charger is also available.
19"- racks, 3 U and wall mounting enclosures are also available (enclosures with protection-class IP 54/64 on request) Order examples
|




































泗水县|
文山县|
金平|
泗洪县|
韶山市|
玉门市|
根河市|
泊头市|
元阳县|
临湘市|
乌海市|
陆丰市|
乌审旗|
天台县|
陕西省|
清原|
陕西省|
巴彦县|
封开县|
武清区|
丰城市|
左贡县|
中西区|
平阴县|
项城市|
内丘县|
阿拉尔市|
宾阳县|
航空|
平陆县|
固安县|
团风县|
通许县|
鹤岗市|
济宁市|
邹平县|
温州市|
渭源县|
汝州市|
罗田县|
城固县|