空氣輸送斜槽可在任何距離間散裝地輸送干燥松散易流態化的粉狀物質，輸送能力可達 1500m 3 /h 。該輸送裝置廣泛適用于建材、冶金、輕化、糧食等行業中水泥成品、水泥生料、粉煤灰、面粉以及磨機、選粉機和窯的喂料等輸送。對粒度大、水分多、流態化性能差的物料不宜選用。

該輸送裝置分為下充氣層、中透氣層和上輸料層，由風機給與低壓小容量的空氣，由充氣層內透過透氣層，使物料流態化，從而實現物料的移動。

該裝置能耗小、無噪音、無污染、無潤滑、少維修，且輸送能力大，輕便，不占用有效空間，布線靈活，容易改變輸送方向。

空氣輸送斜槽只能在一定角度下向下輸送，不能向上輸送。若要向上輸送，請選用空氣提升器系統。風動溜槽的斜度，在工藝布置允許的條件下，采用較大的斜度對輸送有利。其斜度一般為 4 ～ 6% ，輸送粗料時，建議斜度不小于 10% 。

The device can transport dry fluidity powder material in any distance. The transport ability is 1500m 3 /h. It is widely used in building material, metallurgy, light chemical and feed industries etc to feed or transport cement, powder coal and flour of milling and stove. But it is not suitable for the material of great granularity, big washiness and bad fluidity.

The device is divided into three layers. Puff layer is below the device, transport material layer is above and ventilate layer is in the center of device. Low pressure and little volume air supplied by wind machine flow from puff layer to ventilate layer, making the material flowing and realize the moving of material.

It has the features of little cost of energy, no noise, no pollution, no lubrication, low maintain ratio, high carrying ability, lightweight, saving effective place, agility to dispose wire and easy to change transport direction.

It is only can transport in certain angles, not upwards. Otherwise please choose air-elevating system. Great obliquity is good for transporting if the technics disposal permits. Obliquity is always 4 ～ 6%. Commendatory obliquity is more than 10% when transport coarse material.

適宜輸送的物料： 外形圖：

Suitable transported material: Appearance figure:

外形連接尺寸：

Appearance joint dimension: