●12或24個獨立DAC通道

●24位分辨率

●步進掃描電壓為1.2 µ V（整個± 10 V輸出范圍內）

●綜合輸出噪聲 0.3 Vrms

●超低漂移 1 μ V /℃+ 1.5 ppm /℃

●浮地輸出

●輸出電流10 mA

●帶寬可在100 Hz和100k Hz切換

●AWG功能

●自適應快速掃描

●柵極漏電流測量箱

●安裝在LNHR DAC輸出端和采樣端之間

●在運行實驗過程中監測電流

●6個通道并聯

●PA ~ 10 µ A范圍

●不會增加?xùn)艠O電壓噪聲或惡化穩定性

在敏感實驗中應用具有非常低波動的超穩定DC偏置電壓和高分辨率掃描電壓：

●低溫量子實驗中高歐姆門的驅動

●在量子輸運測量中應用源漏電壓

●控制對靜電電荷高度敏感的樣品，如約瑟夫遜結或量子點

噪聲密度譜和累積噪聲（單通道）

The outstanding noise performance of the LNHR DACII is shown here. This plot shows the noise density spectrum (red) and the integrated noise (blue) at 0 V, 5 V, and 10 V output and the low-bandwidth setting (BW=100 Hz). Data for high bandwidth setting (100k Hz) is shown in the user manual. For this specific measurement, the integrated noise from 0.1 Hz to 100 Hz ~170 nVrms at 0 V output; even better than the 300 nV stated in the table above . The European mains-frequency of 50 Hz and some of its harmonics can be identified on the noise density spectrum . However, those peaks do not add significantly to the total noise voltage as seen on the integrated noise . For frequencies above 100 Hz the noise density drops due to 100 Hz LP-filter and reaches the noise floor of 1 nV/√ Hz at 900 Hz originating from the differential amplifier used for measurements.